To Next PageTo Next Page
Need help?Do you have a question about the Ecoflam MAX GAS 350 PAB TC and is the answer not in the manual?
Details on how the flame is monitored by an ionization probe.
Details on safety mechanisms that shut down the burner in case of flame loss or malfunction.
Procedure for attaching, fixing, and removing the burner from the boiler.
Guidelines for installing gas lines, train, and adhering to regulations.
Requirements for electrical installation work by authorized specialists and applicable rules.
Procedure for disconnecting the burner from the mains using an omnipolar shutdown device.
Guidance on setting ionization probe and ignition electrode positions for proper ignition.
Checklist of essential items to verify before commissioning and ionization current measurement.
Adjusting factory settings to meet required output and avoid condensation.
Instructions for fixing and connecting the gas train for PAB version burners.
Procedure for setting the gas solenoid valve according to the gas train manual.
Steps for regulating maximum power, low flame setting, and gas ramp.
Steps to determine output, back-pressure, and minimum gas pressure from diagrams.
Procedure for calibrating the air pressure switch to prevent low air pressure issues.
Instructions for setting the minimum gas pressure switch to ensure correct burner operation.
Disconnect electrical supply before maintenance; be aware of hot components.
Steps for initial fault diagnosis and prerequisite checks before troubleshooting.
Diagnosing and resolving issues related to burner start-up, ignition, and operation.
General