8
Power button
Press
Power-on/Standby.
If Wave 2 is idle for 5 minutes, the LCD and ambient light will turn off automatically
(The power standby time can be set in the app). Press any button to wake them up.
Press and hold
Press and hold it for 3 seconds to shutdown.
Temperature+ /
Temperature-
Press
Setting temperature and cooling/heating temperature range: 16°C-30°C (60°F-86°F).
The temperature cannot be set when using the fan function .
Press and hold
Press and hold the Temperature+ and Temperature- buttons for 3 seconds
to switch temperature units .
Function selector
Press
Switch cooling /heating /fan functions.
When switching between cooling and heating, there will be 2 minutes of down time*
to protect the device.
Press and hold
Press and hold it for 3 seconds to reset Wi-Fi and Bluetooth .
If reconnection is required, please open the EcoFlow app to reconnect.
Mode selector (available for cooling/heating only)
Press
Switch max /sleep /eco /custom modes.
In max mode, Wave 2 operates at high fan speed of 16°C (60°F) for cooling or 30°C
(86°F) for heating by default, and the temperature or fan speed cannot be changed.
In sleep or eco mode, it operates at low fan speed of 26°C (79°F) for cooling or 20°C
(68°F) for heating by default. For eco mode in cooling state, Wave 2 operates for 20
minutes in cooling, then blows air for 10 minutes, and repeats the process.
Press and hold
Press and hold it for 3 seconds to switch real-time ambient temperature /
real-time air outlet temperature .
* As the operating power may uctuate during down time, the remaining charge/discharge
time is inaccurate. Please recheck it when Wave 2 starts cooling or heating.
Control Buttons
Function
selector
Power
button
Mode
selector
Temperature - Temperature + Fan speed
To Next Page
Loading...
Need help?
General
