EcoFlow WAVE - 5. Troubleshooting; Wireless Module Failure; Electric Drive Board Fault; Power Board Fault

17
Fault code Fault name Solution
5 Wireless module failure
Disconnect the power supply (including the battery) and
restart the machine
 Electric drive board fault
Disconnect the power supply (including the battery) and
restart the machine. If the problem persists, upgrade the

 Power board fault
Disconnect the power supply (including the battery pack)
and restart the machine. If the problem persists, upgrade the

 Temperature sensor fault
Disconnect the power supply (including the battery) and
restart the machine
60 Water level fault
Open the drainage port to drain the water, then restart the
machine
61 Cold zone fan fault
Disconnect the power supply (including the battery) and
restart the machine
62 Hot zone fan fault
Disconnect the power supply (including the battery) and
restart the machine
63 or 65 Overheat protection
Remove any obstructions at the hot zone inlet and outlet, leave

64 Overcooling protection
Remove any obstructions at the cold zone inlet and outlet,

Note: If the user still cannot solve the fault after handling the above solutions, please contact the after-sales
personnel for maintenance.
5. Troubleshooting