Instructions for use
To obtain ozonised water to apply to surfaces and/or utensils, it is important to
bear in mind the fact that the machine generates around 5.5 litres per minute
with a static water pressure of 3.5 Bar, which is more than enough time to ge-
nerate the amount of water required for the purpose described.
The exposure time for ozonised water production must not exceed 5 minutes
in an adequately ventilated area. The ozonised water obtained must be used
for the described cleaning, disinfecting, degreasing and deodorising uses within
a maximum of 2 hours in an open container and 5 hours in a closed container
from the time the ozonised water is generated.
Under normal conditions of use, no special protective measures are required,
taking into account adequate ventilation of the area and production times. It is
recommended that you use the outlet shower supplied with Avatar and always
immerse this in the lling container.
Avatar can work with washing machines up to a maximum load of 12 kg.
Once installed, Avatar will automatically interact with the washing machine, so
you will not have to change your method and you will be able to continue using
the washing programs you were using previously.
The wash temperature should be between cold up to a maximum of 40°C.
It is always advisable to set the Avatar ozone concentration at 100% except with
more delicate clothes (linen, silk...) where we suggest that you choose a 50%
ozone generation level.
Note: See section on ozone generation on page 28.
We recommend that you treat stubborn stains as you did prior to using
Avatar. For typical stains, using Avatar will allow you to reduce the amount of
detergent or stop using it altogether.
Instructions for WASHING CLOTHES
3332
USER MANUAL USER MANUAL
English
To Next Page
Loading...