Instructions for use on CUTLERY and UTENSILS
RECOMMENDATIONS: If there is a lot of organic material adhered to the surface to be cleaned, it is recommended to use water at a maximum tem-
perature of 35ºC, and to leave ozonised water to work for the maximum time. Repeat sequence 1 if the dirt persists.
INDICATION: Rinsing with running water is not required once this last step has been done.
STEP 1:
Fill the spray marked with O
3
with
ozonised water
generated by the Ecofrog system.
STEP 2:
Remove organic remains man-
ually
STEP 3:
Spray with ozonised water and
leave to work for 1 to 5 minutes.
STEP 4:
Rub until the dirt is removed and
then dry with paper.
SEQUENCE 1:CLEANING AND DISINFECTION PROCEDURE
Instructions for use on SLICING MACHINES
RECOMMENDATIONS: If there is a lot of organic material adhered to the surface to be cleaned, it is recommended to use water at a maximum tem-
perature of 35ºC, and to leave ozonised water to work for the maximum time. Repeat sequence 1 if the dirt persists.
INDICATION: Rinsing with running water is not required once this last step has been done.
STEP 1:
Fill the spray marked
O
3
with the ozonised
water generated by
the Ecofrog system.
STEP 2:
Turn o and unplug
the machine
STEP 3:
Remove organic re-
mains manually
STEP 4:
Spray with ozonised water and leave to work
for 1 to 5 minutes.
STEP 5:
Rub until the dirt is
removed and then dry
with paper.
SEQUENCE 1:CLEANING AND DISINFECTION PROCEDURE
3736
USER MANUAL USER MANUAL
English
To Next Page
Loading...