Nexa™ Customer Service Reference Guide January 2014 Page 2
CONFIDENTIAL
Installation and Operation
1. Unpacking
Items included in the package:
• Classic Dispenser
• 3 “D” cell batteries (Classic Touchfree Dispenser)
• I/O manual
• Install Kit (1-packs only)- 2 screws and 2 wall mounts
Remove the dispenser from the shipping box and remove the protective bag from the
dispenser.
2. Opening Cover
Find the cover release button at the top of the dispenser.
Push down on the button with your index finger and rotate the front cover down.
3. Installation: TF dispensers Only
CAUTION:
a. The bottom of the dispenser should be mounted about 15cm above horizontal
surfaces. Shorter distances may be acceptable depending on the reflectivity of
the surface over which the dispenser is being mounted.
b. Do not install in showers or in direct contact with water. The dispenser can be
installed by using screws, anchors and tape.
Note: Manual dispensers can be installed near water, however we highly recommend
screw mounting if this is done.
To Next Page
Loading...
Need help?
General
