EasyManua.ls Logo

EcoMotion CORE Pro + eFAT - Battery Mounting Procedures

EcoMotion CORE Pro + eFAT
25 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
You can change the angle of the handlebar by using its top
lever. make sure to re-lock the lever before using the
bike.!
!
!
!
!
Mounting & dismounting of battery
The battery switch has three modes:
(1) A mode in which the battery is shut off and it's unlocked to
the frame (in this mode you can pull out the battery from
the bike or placed it into the bike).
(2) A mode in which the battery is locked into the bike, and it
powered off.
(3) A mode in which the battery is locked into the bike, and it
powered on and ready for use.
In order to switch the key from mode (2) to mode (1) the key
should be pushed into the battery
!
!
EcoMotion Bikes
13
WARNING! After adjusting the handlebar height and before
riding the bike, make sure that the handlebar is well-locked in
its new position, by strongly pushing it down to the ground.
IMPORTANT! Make sure that while mounting the battery back into the frame,
the battery is sliding on its allocated rail, if the battery is misplaced it may get
stuck.