•
Turn on the power by switching the battery key to “mode (3)”,
and short press on the Power button.!
The bike is ready for use
•
You can switch PAS speed levels by pressing on the PAS
Control buttons (+/-). !
PAS level "0" - without support , PAS level "5"- strongest
support.
•
You can use the TAG system any time the display is on.
•
By pressing on the SET button you can view the following
info: remaining distance to go, trip duration , trip mileage,
and total mileage of the bike .
•
At any given time, the display will show the following info:
battery voltage, battery capacity, current ride speed & current
power usage.
•
The front light, rear-light & the horn, controlled from the Horn
& Lights buttons which located at the left side of the
handlebar .
•
Turn off the bike by long press on the Power button
To Next Page
