EcoMotion CORE Pro + eFAT - PAS System, Motor, and Charging Problems

EcoMotion Bikes
25
Problem
Possible cause
Solution
Motor runs without
using TAG / PAS
systems
Faulty PAS sensor
Replace sensor and
retest
Faulty throttle
Replace throttle and
retest
Wire short
Replace main cord and
throttle cord and retest
Faulty controller
Replace controller and
retest
TAG system doesn't
work
Motor shutdown
system operated
Make sure that bake
handles in their place
Faulty throttle
Replace the throttle
and retest
Faulty controller
Replace controller and
retest
Throttle button not
pressed in
press in the shutdown
button
Display rupture wire
Replace the display
and test
Motor make a
“drilling” noise and
reduce power /
shuts off
Low battery
Charge the battery full
charge
Motor gear
damaged
Replace motor gears
Charger doesn't
charge the battery
Burnt fuse
Replace the fuse
Faulty charger
Replace the charger
Outlet has no power
Check a different outlet
Charger shows s
full charge in an
unusually short
amount of time
Faulty charger
Replace the charger
Battery lifetime is
over / shortened
Replace the battery
Charger indicator
light flashes and not
change into red (not
charging)
Faulty charger
Replace the charger
Bicycle has
intermittent power
Loose connector
Check all connectors
Loose fuse
Check fuse connector
Damaged wires
Inspect all wires