Econ 3300 Series - Page 30

Installation and Operating manual
Econ
®
Series 3300 Smart Valve Positioner www.eriks.com www.eriks.com
30
6.3.5.8 Custom End Setting Mode (CST ENd)
Custom End Setting Mode allows the user to set any specific point as end position. For
example, the end point can be set at input signal of 11mA. The difference between zero
and end point must be greater or equal to 4mA.
6.3.5.9 Interpolation Mode (ITP OFF / ON)
Positioner can control the valve accurately if the feedback lever angle range is within
designed range. For some instance, the angle exceeds the suggested range angle.
Positioner can reduce the error through interpolation.
⇨
<UP>/<DOWN>
⇨
<ESC>
3 times
<ENTER>
⇨
<ENTER>
⇨
<DOWN>
7 times
⇨
<ENTER>
⇨
<UP>/<DOWN>
⇨
<ESC>
3 times
<ENTER>
⇨
<ENTER>
⇨
<DOWN>
8 times
⇨
<ENTER>
⇨
<UP>/<DOWN>
⇨
<ESC>
3 times
<ENTER>