Ecosoft ROBUST 1000 User Manual

18
This manual is the intellectual property of Ecoso. Copying and reprinng is prohibited. © 2017
INSTALLATION AND OPERATION GUIDELINES FOR REVERSE OSMOSIS SYSTEMS
ECOSOFT ROBUST 1000, ROBUST 1500, ROBUST PRO, ROBUST 3000
Filter type
Service life*
RObust 1000 RObust 1500 RObust PRO RObust 3000
Pre–lters
and post-lters**
8 000 L but not
less than once
in 3 months.
Service life
depends on
feed water
quality and
intensity of
usage
8 000 L but not
less than once
in 3 months.
Service life
depends on
feed water
quality and
intensity of
usage
5 000 L but not
less than once
in 3 months.
Service life
depends on
feed water
quality and
intensity of
usage
15 000 L but
not less than
once in 3
months. Service
life depends
on feed water
quality and
intensity of
usage
Reverse osmosis
membranes
24 000 L but
not less than
once a year
40 000 L but
not less than
once a year
40 000 L but
not less than
once a year
80 000 L but
not less than
once a year
* Service life depends on quality of feed water.
** In Robust Pro reverse osmosis system all lters should be replace at the same me.
6.1. AVERAGE LIFESPAN OF SYSTEMS COMPONENTS
6.2. FILTERS REPLACEMENT
1 Without disconnecng the system from the mains, turn o the water supply valve on the
system, turn the tank ball valve to the "Closed" posion.
For systems with a puried water faucet: open the tap on the sink, turn o the water supply
valve on the system, turn the tank ball valve to the "Closed" posion.
For systems without a faucet, open the tap for supplying puried water to the consumer.
2 Wash your hands with anbacterial soap thoroughly.
3 Aer water has stopped running from puried water faucet, unplug the RO system from the
mains and screw o the three lter housings. Take care as the bowls will be full of water.
4 Remove spent lters.
5 Wash the bowls thoroughly with non-aromac soap, and then rinse with water.
6 Install new lters in bowls in the correct sequence from le to right: polypropylene, GAC,
carbon block (for systems RObust 1000, 1500, Pro), or two acvated carbon lters (for
RObust 3000). For the RObustPro system also insert a special RObustPro replacement lter.
7 Start rinsing pre–lters:
RObust 1000: disconnect the inlet tubes from the covers of the two rst membrane holders
and guide them into the bucket. Open system’s feed valve. Pass the required volume of water
unl there are no carbon nes in rinsewater. Install the free tube ends back in push-t ngs
and lock with locking clips.
RObust 1500, RObust Pro, RObust 3000: open a special rinse valve and pass the required
volume of water to the bucket unl there are no carbon nes in rinsewater.

Ecosoft ROBUST 1000 Specifications

General

Brand	Ecosoft
Model	ROBUST 1000
Category	Water Dispenser
Language	English