02.12.2022 Rev. 12
7. INSTALLATION
7.1. Burner Installation Picture
1- Drift Bolts
2- Burner
3- Boiler Connection Flange
4- Gasket
5- Boiler Studs
Ø In the installation of the burner, use the installation materials supplied with the burner.
Ø Secure the burner connection flange onto the burner cover by 4 bolts. Gasket must be connected
such that it will remain between connecting flange and boiler cap.
After completing the installation of the burner on the boiler:
Ø Connect the oil feed pipes.
Ø Connect the burner panel to the mains by a cable suitable for the rated power.
Device must be shipped in original packaging!
Do not lift the device holding from servomotor, gas valve, impulse pipes or pressure switch
during installation!
Clean the inside of fuel line thoroughly before installing the burner to the fuel line. Any damage
that may occur due to solid objects and metal particles from the fuel line shall not be covered by
our company.
To Next Page
