Wi-Fi Connection
Before Wi-Fi setup, make sure DEEBOT, mobile phone, and Wi-Fi network meet the following requirements.
DEEBOT and Mobile Phone Requirements
DEEBOT is fully charged and the power switch of DEEBOT is turned on.
Wi-Fi status light slowly flashes.
Turn off mobile phone’s cellular data (you can turn it back on after setup).
Wi-Fi Network Requirements
You are using a 2.4GHz or 2.4/5 GHz mixed network.
Your router supports 802.11b/g/n and IPv4 protocol.
Do not use a VPN (Virtual Private Network) or Proxy Server.
Do not use a hidden network.
WPA and WPA2 using TKIP, PSK, AES/CCMP encryption.
WEP EAP (Enterprise Authentication Protocol) is not supported.
Use Wi-Fi channels 1-11 in North America and channels 1-13 outside North America (refer to local regulatory
To Next Page
Loading...
