To Next PageTo Next Page
Need help?Do you have a question about the EcoWater ESD 2502R30 and is the answer not in the manual?
General| Brand | EcoWater |
|---|---|
| Model | ESD 2502R30 |
| Category | Water System |
| Language | English |
Details warranty coverage for mineral tank, salt tank, and other parts.
Instructions on how to get service and what is covered.
Conditions and limitations for warranty validity and performance.
Bond from Safeco Insurance guaranteeing EcoWater Systems LLC obligations.
Guidelines for safe installation, handling, and environmental considerations.
Warnings about water temperature, pressure, and electrical connections.
Guidance on proper disposal of electrical and electronic equipment.
Detailed technical specifications including capacity, flow rates, and pressure limits for models.
Steps to turn off water supply and water heater power before installation.
Instructions for draining household pipes and removing packing materials.
Procedure for installing adaptors or the bypass valve and securing them.
How to connect the drain hose, including air gap and routing considerations.
Steps to install the brinewell, brine valve, and cover in the brine tank.
Connecting water supply lines and installing ground clamp if needed.
Connecting drain hoses, brine tubing, power, and checking for leaks.
Procedure for disinfecting the softener using bleach and regeneration.
How to set the current time on the electronic demand timer.
Adjusting the water hardness setting based on water analysis.
Configuring regeneration start time, backwash, and rinse times.
Understanding and enabling the "High Efficiency" feature for California installations.
How to manually initiate a recharge and understanding program memory.
Interpreting error codes and understanding the water meter and demand timer functions.
Guidance on refilling salt, recommended salt types, and dealing with salt bridges.
Instructions for cleaning the critical nozzle and venturi assembly.
Procedures for cleaning and adding resin to the softener bed.
How to check and change the model code settings for the unit.
