PRODUCT OPERATION
To remove, hold the fuselage with
one hand, grasp the clean water
tank groove and clean water tank
release with the other hand and
pull back.
Clean Water Tank
Release
Please align the groove on the right
side of the roller with the drive shaft,
and then press down on the left side
of the roller until it is installed in
place.
First align the snap of the roller
cover, then press the roller cover
and hear a "click" to install
successfully.
Assemble Roller Assemble Roller Cover
Unscrew the cap, and inject tap
water (under 40°C/
104) to the max
water level. Close the cap of the
clean water tightly to make sure it is
tight and not loose.
Align the bottom of the clean water
tank with the groove and push the
tank until it "clicks" into place.
EN
8
1
2 3
click
To Next Page
Loading...
