31
Using BIOS
Quick Boot (Enabled)
If you enable this item, the system starts up more quickly because of the elimination of
some of the power on test rutines.
1st/2nd/3rd Boot Device
Use this item to determine the device order the computer used to look for an operating
system to load at start-up time. The devices showed here will be different depending on the
exact devices installed on your motherboard.
Try Other Boot Device (Yes)
If you enable this item, the system will also search for other boot devices if it fails to find
an operating system from the first boot device.
BootUp Num-Lock (On)
This item determines if the Num Lock key is active or inactive at system start-up time.
Configure DRAM Timing by (Enabled)
This item allows you to enable or disable the DRAM timing defined by the Serial Presence
Detect electrical.
Hyper Threading Technology (Enabled)
You can set “Disabled” or “Enabled” to control HT CPU support in O.S. Set “Enabled” to
test HT CPU function.
Auto Detect DIMM/PCI Clk (Enabled)
When this item is enabled, BIOS will disable the clock signal of free DIMM/PCI slots.
Spread Spectrum (Disabled)
If you enable spread spertrum, it can significantly reduce the EMI (Electro-Magnetic
interface) generated by the system.
Press <Esc> to return to the main menu setting page.
Max CPUID Value Limit (Disabled)
Enable this item when users intend to install NT4.0 to make the system work properly with
Prescott and LGA775 CPU.
DDR Voltage Control (Normal)
This item enables users to adjust the DDR voltage. We strongly recommend users leave this
item at its default value.
PCI-E Voltage Control (Normal)
This item enables users to adjust the PCI-E voltage. We strongly recommend users leave this
item at its default value.
To Next Page
Loading...
Need help?
General
