35
Using BIOS
Integrated Peripherals
This page sets up some parameters for peripheral devices connected to the system.
Onboard IDE Controller (Enabled)
SATA Configuration (IDE)
Use this item to show the Serial ATA Configuration options: Disabled, Compatible,
Enhanced.
Onboard AUDIO Function (Enabled)
Onboard LAN Function (Enabled)
Onboard LAN Boot ROM (Disabled)
Press <Esc> to return to the main menu setting page.
Use this item to enable or disable the onboard IDE interface.
Onboard SATA Mode (Enabled)
Use this item to enable or disable the onboard SATA mode.
USB Functions (Enabled)
Use this item to enable or disable the USB function.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto
allows the system to detect the presence of USB device at startup. If detected, the
USB controller legacy mode is enabled. If no USB device is detected, the legacy USB
support is disabled.
Onboard JMB361 (AHCI Mode)
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Integrated Peripherals
Onboard IDE Controller Enabled
SATA Configuration IDE
Onboard SATA Mode Enabled
Onboard AUDIO Function Enabled
Onboard LAN Function Enabled
Onboard LAN Boot ROM Disabled
USB Functions Enabled
Legacy USB Support Enabled
Onboard JMB361 AHCI Mode
Help Item
F10: Save ESC: Exit+/-/: Value
Enter : Select
F9: Optimized Defaults
F1:General Help
: Move
DISABLED: disables the
integrated IDE
Controller.
Enabled: enables both
Controllers.
Use this item to enable or disable the onboard Audio function.
Use these items to enable or disable the onboard LAN function.
Use this item to enable or disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
Use this item to enable or disable the onboard JMB361 mode.
To Next Page
Loading...
Need help?
General
