42
Using BIOS
Supervisor Password (Not Installed)
This item indicates whether a supervisor password has been set. If the password has
been installed, Installed displays. If not, Not Installed displays.
Change Supervisor Password (Press Enter)
You can select this option and press <Enter> to access the sub menu. You can use the
sub menu to change the supervisor password.
Supervisor Password
This page helps you install or change a password.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Supervisor Password
Install or Change the
password.
Help Item
F10: Save ESC: Exit+/-/: Value
F9: Optimized Defaults
F1:General Help
: Move
Press <Esc> to return to the main menu setting page.
Load Default Settings
This option opens a dialog box to ask if you are sure to install optimized defaults
or not. You select [OK], and then press <Enter>, the Setup Utility loads all default
values; or select [Cancel], and then press <Enter>, the Setup Utility does not load
default values.
Supervisor Password : Not Installed
Change Supervisor Password Press Enter
Enter : Select
Press <Esc> to return to the main menu setting page.
NB Clk (1800MHz)
This item shows the frequency of Northbridge clock.
AMD Phenon (tm) 8550 Triple-Core Processor Speed (2200MHz)
This is display-only field and displays the information of the CPU installed in your
computer.
Warning: Please pay attention that doing overvoltage may result in dam-
age to hardware.
Use this item to enable or disable the Voltage Function. If enable, users can increase
the hardware voltage through BIOS settings.
Voltage Function (Disabled)
To Next Page
Loading...
Need help?
General
