H110M4-C43(C33)/B150M4-C43 USER MANUAL
The informaon in this document is subject to change without noce. The
manufacturer makes no representaons or warranes with respect to the contents
hereof and specifically disclaims any implied warranes of merchantability or
fitness for any parcular purpose. The manufacturer reserves the right to revise this
publicaon and to make changes from me to me in the content hereof without
obligaon of the manufacturer to nofy any person of such revision or changes.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protecon against harmful interference in a residenal
installaon. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instrucons, may cause
harmful interference to radio communicaons. However, there is no guarantee that
interference will not occur in a parcular installaon. If this equipment does cause
harmful interference to radio or television recepon, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separaon between the equipment and the receiver
• Connect the equipment onto an outlet on a circuit different from that to
which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Shielded interconnect cables and a shielded AC power cable must be employed with
this equipment to ensure compliance with the pernent RF emission limits
governing this device. Changes or modificaons not expressly approved by the
system’s manufacturer could void the user’s authority to operate the equipment.
Federal Communications Commission (FCC)
Disclaimer
Declaration of Conformity
This device complies with part 15 of the FCC rules. Operaon is subject to the follow-
ing condions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference
that may cause undesired operaon.
Limits and methods of mesurement of radio disturbance char-
acteriscs of informaon technology equipment
EN 55022
EN 61000-3-2
Disturbances in supply systems caused
EN 61000-3-3
Disturbances in supply systems caused by household appli-
ances and similar electrical
equipment “ Voltage fluctuaons”
EN 55024
Informaon technology equipment-Immunity characteriscs-
Limits and methods of measurement
EN 60950
Safety for informaon technology equipment including electri-
cal business equipment
CE marking
This device is in conformity with the following EC/EMC direcves:
®
To Next Page
Need help?
General
