40
Using BIOS
Press <Esc> to return to the Integrated Peripherals page.
IDE DMA transfer access (Enabled)
This item allows you to enable the transfer access of the IDE DMA then burst onto the PCI
bus and nonburstable transactions do not.
Serial-ATA Controller (All Enabled)
This item allows you to enable or disable the onboard SATA controller.
IDE Prefetch Mode (Enabled)
The onboard IDE drive interface supports IDE prefetching, for faster drive access. If you
install a primary and secondary add-in IDE interface, set this field to Disabled if the
interface does not support prefetching.
IDE HDD Block Mode (Enabled)
Enables this field if your IDE hard drive supports block mode. Block mode enables BIOS to
automatically detect the optimal number of block read and writes per sector that the drive
can support and improves the speed of access to IDE devices.
RAID Config (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Item Help
Menu Level
RAID Enable [Disabled]
SATA 1 Primary RAID Disabled
SATA 1 Secondary RAID Disabled
x
x
RAID Enable (Disabled)
This item allows you to enable or disable the onboard RAID function of RAID function of
RAID supporting devices.
•SATA 1 Primary/Secondary RAID (Disabled)
These two items enable or disable SATA 1 Primary/ Secondary RAID.
Phoenix-Award WorkstationBIOS CMOS Setup Utility
RAID Configuration
Press <Esc> to return to the Integrated Peripherals page.
F5:Previous Values F6: Fail-Safe Defaults F7:Optimized Defaults
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
Primary Master/Slave UDMA (Auto)
Each IDE channel supports a master device and a slave device. This motherboard supports
UltraDMA technology, which provides faster access to IDE devices.
If you install a device that supports UltraDMA, change the appropriate item on this list to
Auto. You may have to install the UltraDMA driver supplied with this motherboard in order
to use an UltraDMA device.
To Next Page
Loading...
Need help?
General
