Name: Edge-Core ES3510
Brand: Edge-Core
Rating: 4 (1 reviews)

Other manuals for Edge-Core ES3510

Management Guide624 pages

Questions and Answers:

A
alicecarterJul 30, 2025
How to troubleshoot connection issues with Edge-Core Network Router using Telnet, web browser, or SNMP?
- C
  Cheryl WyattJul 31, 2025
  If you are unable to connect to the Edge-Core Network Router using Telnet, a web browser, or SNMP software, ensure the device is powered on and check the network cabling between your management station and the switch. Verify that you have a valid network connection to the switch and the port is enabled. Also, ensure the VLAN interface connected to your management station has a valid IP address, subnet mask, and default gateway. Make sure your management station's IP address is in the same subnet as the switch's IP interface. If connecting via a tagged VLAN group IP address, confirm your management station and intermediate switches are configured with the appropriate tag. If using Telnet, you might have exceeded the maximum concurrent sessions; try again later.
L
Latoya HarrisAug 4, 2025
What to do if I cannot connect to Edge-Core Network Router using Secure Shell?
- T
  Thomas ThomasAug 4, 2025
  If you're having trouble connecting to the Edge-Core Network Router using Secure Shell (SSH), it might be due to exceeding the maximum number of concurrent Telnet/SSH sessions; try again later. Ensure that the SSH server's control parameters are correctly configured on the switch and that the SSH client software is properly configured on your management station. Confirm that you've generated a public key on the switch and exported it to the SSH client. Also, verify that you've set up an account on the switch for each SSH user, including username, authentication level, and password. If using public key authentication, ensure you've imported the client's public key to the switch.
M
maryschwartzAug 8, 2025
How to access Edge-Core Network Router configuration program via serial port?
- A
  Angela JacksonAug 8, 2025
  To access the on-board configuration program of the Edge-Core Network Router via a serial port connection, ensure your terminal emulator program is set to VT100 compatible, with 8 data bits, 1 stop bit, no parity, and 9600 bps. Also, verify that the null-modem serial cable conforms to the pin-out connections provided in the Installation Guide.