Edge-Core ES3510 - Desktop or Shelf Mounting; Installing an Optional SFP Transceiver; Figure 3-4 Attaching the Adhesive Feet; Figure 3-5 Inserting an SFP Transceiver into a Slot

Installing an Optional SFP Transceiver
3-5
3
Desktop or Shelf Mounting
1. Attach the four adhesive feet to the bottom of the first switch.
Figure 3-4 Attaching the Adhesive Feet
2. Set the device on a flat surface near an AC power source, making sure there
are at least two inches of space on all sides for proper air flow.
3. If installing a single switch only, go to “Connecting to a Power Source” at the
end of this chapter.
4. If installing multiple switches, attach four adhesive feet to each one. Place each
device squarely on top of the one below, in any order.
Installing an Optional SFP Transceiver
Figure 3-5 Inserting an SFP Transceiver into a Slot