5
GENERAL OPERATION
Hose Handle Attachments - using the hose with other attachments
If the Edge is attached to the wand, turn cleaner OFF before removing hose
handle from the wand.
To disconnect the hose from the wand:
1. Press the gray “thumb-saver” lock button, then pull on the handle to
disconnect from the wand.
2. Slide attachments firmly on handle as needed.
Wand Assembly Attachments
To remove the powerhead from the wand:
1. Lock wand in the straight up position.
2. Press easy release pedal with foot, located on
the left side, and pull the wand straight up out
of the Edge.
3. Put desired attachments on wand as needed.
EDGE ATTACHMENTS
The Edge is controlled by pressing the three
position on/off power control switch located on
the hose handle. When the switch is pushed to
the left (I) it turns on the vacuum only. When the
switch is pushed to the right (II) it operates both
the vacuum and the brush roller. The headlight
will operate when the Edge is turned on.
The powerhead has a height adjustment pedal for
various carpet heights. Use the low setting (#1)
for short napped carpets and the highest setting
(#5) for plush carpets. To change the height of
the Edge, simply, apply pressure to the height
adjustment pedal with your toe.
CAUTION
Do not attach or remove handle or wands while cleaner is ON.
This could cause sparking and damage the electrical contacts.
To Next Page
Loading...