6
Edge Cleaner
The Edge has built-in channels on both sides that
allow dirt and debris to flow in from the edges freely.
Vacuuming close to baseboards and furniture will
capture dirt trapped at carpet edges.
Overload Protector
The Edge has built-in protection against motor and belt damage should an
obstruction cause the roller brush to suddenly stop. The overload protector
will activate when the powerhead consumes more power than planned or an
obstruction makes the brush hard to turn. If this occurs:
• Turn off the vacuum and remove hose handle from the wand.
• Remove the object that is preventing the brush from rotating.
• 30 - 60 seconds of cool-down time may be required for the circuit breaker to
automatically reset.
• Reconnect the hose handle to the powerhead and proceed to clean.
Suction Control
The suction control allows you to easily change the vacuum suction for different
fabric and carpet weights. Opening the control decreases suction for drapes and
lightweight rugs, while closing the control increases suction for upholsteries and
carpets.
Handle Release Pedal
The handle release pedal allows you to lower the
wand and handle for extended and easier reach
under furniture.
PERFORMANCE FEATURES
Channels
Handle Release
To Next Page
Loading...