7
WARNING:
Always unplug electrical cord and vacuum hose before servicing and maintaining
the Edge Electric Powerhead. Failure to do so could result in electrical shock or
personal injury from cleaner suddenly starting. Always follow all safety precautions
specified when caring for your Edge.
MAINTENANCE AND CARE
Brush Cleaning
Check the brush roll and brush support areas frequently in order to maintain optimum
efficiency. If hair, string, thread, carpet fiber or lint becomes wound around the brush roll,
remove by unwinding them by hand or carefully cutting with scissors. If buildup becomes
excessive, disconnect the EDGE Powerhead from the wand assembly and follow the Brush
Replacement steps on page 8. Instructions can also be found under the light cover.
Belt Removal and Replacement
The belt should also be checked periodically
to be sure it is in good condition. It should
be replaced if it is stretched, cracked or
broken. If the belt needs replaced, use only
Edge Belt #9204-01.
To remove belt:
1. Remove cover
• Depress Neck Release Pedal and remove
(8) #10 Torx screws, set aside for
reassembly. Note: 3 longer screws are in
front of the brush roller.
• Turn Edge right side up and lift cover
making sure pedals stay secure in
cover housing.
2. Remove secondary cover
• Remove clear plastic neck release lever
and return spring-set aside.
• Remove 3 #10 Torx screws and set
aside
• Lift secondary cover and slide by wiring
harness.
Remove 8 Torx Screws
Remove 3 Torx Screws
To Next Page
Loading...