Edge REVOLVER User Manual

7
1 Remove the keys from the ignition and disconnect both batteries. Failure to do
so may cause damage to the PCM and Revolver.
2 Locate the wiring harness on the re wall in the engine compartment that
connects to the PCM. Using a 10mm socket remove the bolt and slide the
connection out of the rewall.
Required Tools
- 10mm Socket - 5.5mm Socket
- 7mm Socket - Screw driver
REVOLVER INSTALLATION 1998-2003 Trucks

Edge REVOLVER Specifications

General

Brand	Edge
Model	REVOLVER
Category	Automobile Accessories
Language	English