EdgeStar AP8000W Service Manual

EdgeStar AP8000W

13 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

EdgeStar, 8606 Wall St, Suite 1800, Austin, TX 78754

support.edgestar.com • service@edgestar.com • edgestar.com

*Warranty service should be performed by an authorized service representative only.

SERVICE MANUAL

EdgeStar Small Room Portable Air Conditioner

with 71 Pint Dehumidifier

MODEL:

AP8000W

Document Type: Service Manual

Version: V1.0 04112018

CAUTION: READ ALL SAFETY PRECAUTIONS IN THIS

MANUAL BEFORE SERVICING THE UNIT

Table of Contents

Other manuals for EdgeStar AP8000W

Owner's Manual24 pages

Questions and Answers:

E
etuckerAug 19, 2025
Why is my EdgeStar AP8000W not functioning at all?
- L
  Lisa GonzalezAug 19, 2025
  Your EdgeStar air conditioner might not be working due to several reasons. First, ensure the unit is properly plugged into a grounded outlet. If it is, check the LCDI power cord and press the Reset button. It's also possible that the unit isn't receiving sufficient power, so try moving it to another outlet and check your circuit breaker. A full water reservoir can also cause this issue; drain the unit and restart it. If no indicator lights turn on, it could be a disconnected control panel, in which case you should contact customer service.
S
Sara Rodriguez MDAug 21, 2025
What to do if my EdgeStar AP8000W remote control does not work?
- S
  smithtinaAug 21, 2025
  If the indicator light on your EdgeStar Air Conditioner remote isn't turning on, start by installing new batteries. If that doesn't work, try replacing the batteries. Also, make sure the batteries are installed correctly. If the problem persists, it could be a defective remote control, and you should contact customer service.
S
Steven RomeroAug 23, 2025
Why is my EdgeStar Air Conditioner making a loud noise?
- B
  Benjamin ReynoldsAug 23, 2025
  If your EdgeStar air conditioner is producing excessive noise, first ensure that the unit is placed on a level surface. Check if a foreign object has jammed the fan and remove it if necessary. Also, consider whether the floor below the unit is uneven and, if so, move the unit to a level surface.
G
Glenn BondAug 26, 2025
What to do if my EdgeStar AP8000W runs for a while and then trips the power cord?
- L
  Lisa CordovaAug 26, 2025
  The air conditioner may be plugged into an outlet that can not supply the correct amount of current. Contact an electrician if the unit works in a different room or circuit.
E
Eric WilliamsAug 28, 2025
Why is my EdgeStar AP8000W making a continuous metallic knocking sound?
- L
  Lawrence BowersAug 28, 2025
  If your EdgeStar Air Conditioner is making a continuous metallic knocking or pinging sound, it might have been shipped on its side. Shut off the unit, let it sit on a level surface for at least 24 hours, and then restart it. If the problem continues, it could indicate a damaged compressor, and you should contact customer service.
K
Kenneth DavilaAug 30, 2025
What to do if my EdgeStar AP8000W Air Conditioner is leaking?
- L
  Lisa LopezAug 30, 2025
  If your EdgeStar air conditioner is leaking, first check if the drain plug is removed and attach it. If the leaking continues, there may be a cracked base pan, in which case you should contact customer service.
D
Dale WilliamsSep 1, 2025
What to do if the control panel lights blink randomly on my EdgeStar AP8000W?
- T
  Thomas GallegosSep 1, 2025
  If the control panel lights on your EdgeStar Air Conditioner are blinking randomly, the unit may have a faulty control panel. Contact customer service.
T
thomaswilliamsSep 4, 2025
Why is my EdgeStar AP8000W Air Conditioner not blowing cold air?
- J
  Jacob PerezSep 4, 2025
  If your EdgeStar Air Conditioner isn't blowing cold air, several factors could be at play. First, cooling will not occur until room temperature rises above 61ºF(16ºC). Ensure that the unit is set to cooling mode, indicated by a blue light. Also, verify that the set temperature isn't too high; if it is, simply lower it. A dirty air filter can also impede cooling, so clean the filter. Check that the exhaust air duct is correctly installed and free from blockages. In more complex cases, there might be a refrigerant leak, requiring professional repair and recharge, or the evaporator might be frosted, in which case the unit needs to defrost before resuming normal operation.
M
Mia McclureSep 6, 2025
What to do if my EdgeStar AP8000W blows cold air but does not lower room temperature?
- M
  Michael Long IIISep 6, 2025
  There are several reasons why your EdgeStar Air Conditioner might not be lowering the room temperature, even when blowing cold air. First, make sure the fan speed isn't set too low; increasing it can improve airflow. Check that the exhaust air duct is correctly installed and free of any blockages. The unit might be inadequate if the room area is too large; consider reducing the room size or adding another unit. Ensure all windows and doors are closed. Also, the unit may not work effectively if the ambient temperature is above 90°F. Finally, too many heat sources in the room can hinder cooling; remove or shut off these sources and minimize direct sunlight by closing curtains or blinds.
A
Andrew ThomasSep 9, 2025
How to fix an EdgeStar AP8000W that does not turn on?
- H
  hfloresSep 9, 2025
  There are several potential causes if your EdgeStar Air Conditioner does not turn on. Check if the wall plug is properly inserted into the outlet. A blown fuse or tripped circuit breaker could also be the issue; replace the fuse or reset the breaker. Ensure the power cord is not tripped by pressing the RESET button, and replace it if damaged. Verify that the unit is turned ON and set to the desired setting. A disconnected ribbon cable to the control panel or loose wiring on the main PCB could also be the culprit; reconnect these after removing the outer shell. Lastly, if the condensate water tray is full, drain it and ensure the water level switch is operating correctly.

EdgeStar AP8000W Specifications

General

Description of product	Portable Air Conditioner
Model	AP8000W
Color	White
Voltage/Frequency	AC 115V~60Hz
Input Power	840W
Current	7.9A
Dehumidifying capacity	71 Pints/Day
Timer	24 Hour
Coolant	R-410A

Weight and Dimensions

Dimensions WxHxD	19 1/4” 24 3/4” x13 1/4”
Weight	56 lbs

Related product manuals

Preview: EdgeStar AP450Z

EdgeStar AP450Z

Preview: EdgeStar AP410W

EdgeStar AP410W

Preview: EdgeStar AP550Z

EdgeStar AP550Z

EdgeStar AP410HS

EdgeStar AP310SS

Preview: EdgeStar AP13500G

EdgeStar AP13500G

Preview: EdgeStar AP14003W

EdgeStar AP14003W

Preview: EdgeStar AP12001S

EdgeStar AP12001S

Preview: EdgeStar AP14001HS

EdgeStar AP14001HS

Preview: EdgeStar AP14000HS

EdgeStar AP14000HS

Preview: EdgeStar AP12000S-1

EdgeStar AP12000S-1

EdgeStar AP12005ECO