The body of the beverage
cooler is electrified.
The unit is not grounded
properly.
Contact your local electrician
to test your electrical
grounding system.
Frost is forming in the
beverage cooler.
The environment is humid.
Manual defrosting is required;
unplug the unit to allow the
frost to melt. If frost builds up
frequently, you can move the
unit to a location with a
warmer temperature,
minimize the number of times
you open the door, or check
the door gasket for a good
seal.
The ambient temperature is
too low.
The door gasket is not
installed properly.
The door is being opened too
frequently.
The door will not shut
properly.
Make sure the cooler is on a
level surface.
The door gasket is dirty.
The door gasket is not
installed correctly.
Make sure the door gasket is
correctly installed.
The shelves are incorrectly
installed.
Make sure the shelves are
correctly installed.
The temperature sensor is
experiencing an “Open
Circuit.”
The temperature sensor is
unplugged. The temperature
sensor is faulty.
The temperature sensor is
experiencing a “Short.”
The temperature sensor is
faulty.
To Next Page
Loading...
Need help?
General
