4
Important Notes:
Choose a location that has ambient temperatures above 50° F and below 95° F. Operation
outside these temperatures may result in lowered efficiency or cause other adverse
effects.
This unit MUST be installed indoors in an area protected from the elements, e.g. wind,
rain, water spray or drips.
The beverage cooler should not be located next to ovens, grills, or other high heat
sources.
Do not kink or pinch the power supply cord between the beverage cooler and the wall or
cabinet.
Installation Clearance Requirements
When installing the Beverage Cooler, follow the recommended spacing dimensions shown.
To ensure proper ventilation, allow at least 5” of clearance at the back, 3” at the top, and
3” at the sides.
The beverage cooler should be installed on a firm and level surface that will be able to
support the entire weight of a fully loaded unit. It is important for the beverage cooler to be
level in order to work properly. If needed, you can adjust the height of the beverage cooler
by rotating the feet. See the “Leveling the Beverage Cooler” section.
A standard electrical supply (115 VAC only, 60 Hz), properly grounded in accordance with
National Electrical Code and local codes and ordinances, is required.
Important Notes:
• Choose a location that has
ambient temperatures above
50°F and below 95°F.
Operation outside these
temperatures may result in
lowered efficiency or cause
other adverse effects.
• This unit MUST be installed
in an area protected from the
elements, e.g., wind, rain,
water spray or drips.
• The refrigerator should not
be located next to ovens,
grills or other high heat
sources.
• Do not kink or pinch the
power supply cord between
the refrigerator and wall or
To Next Page
Loading...
Need help?
General
