10.9 Interior fan motors cycle on and off even when the set temperature has been reached
In order to circulate the air and maintain the set temperature inside the cabinet the inside fans
must cycle on and off when the compressor is off in Dynamic Cooling Mode. The fans will cycle
ON and OFF approximately every 20 seconds. This cycle is normal and meant both to circulate
the air as well as ensure the continued operational status of the fans. If the fan stops completely
and does not complete this cycle the fan is non-operational.
Dynamic Cooling Mode is the factory preset. If the user wants to reduce noise, they can switch
to Silent Mode by pressing and holding the UP key for at least 5 seconds. You will hear three
beeps to confirm silent mode is on.
10.10 Cannot get the upper and lower temperatures to set separately - they both adjust at
the same rate (if you set one higher the other goes higher etc).
This is normal. The temperature set for the LOWER ZONE must always be the same or higher
than that in the UPPER ZONE. So when the user is adjusting the temperature for one zone, if
the above condition can't be met, the temperature of the second zone will change automatically
to meet the condition.
10.11 The control panel doesn’t seem to work.
This unit’s control panel has an auto lock feature that prevents tampering with temperature or
power settings. This feature activates automatically 2 minutes after the last touch of a key on the
control panel. To unlock the control panel, press and hold the UP and DOWN keys for 5 seconds.
10.12 The fans are running constantly.
In order to circulate the air and maintain the set temperature inside the cabinet the inside fans
must cycle on and off when the compressor is off in Dynamic Cooling mode. The fans will cycle
ON and OFF approximately every 20 seconds. This cycle is normal and meant both to circulate
the air as well as ensure the continued operational status of the fans. If the fan stops completely
and does not complete this cycle the fan is non-operational.
10.13 Digital display functions. But the unit does not cool.
Check to see if the unit is in “Eco Demo mode”. Press and hold the “UP”, “DOWN” and “LIGHT”
keys at the same time for at least 5 seconds to exit Eco Demo mode.
10.14 Digital display, light and sound do not work but the unit is cooling well.
The unit maybe in Sabbath mode.
To Next Page
Loading...
