10
ELECTRIC SHOCK HAZARD!
• Plug into a grounded 3-prong outlet.
• Never remove the grounding prong from the plug.
• Never use an adapter to bypass the grounding prong.
• DO NOT use an extension cord.
• Failure to follow these instructions can result in re, electrical shock, or death.
!
Electrical Requirements
Recommended Grounding Method
Before you move your Refrigerator into its nal location, it is important to make sure you have the
proper electrical connection:
A standard electrical supply (115 V, 60Hz), properly grounded in accordance with the National Electrical
Code and local codes and ordinances is required.
It is recommended that a separate circuit, serving only your refrigerator, be provided. Use receptacles
that cannot be turned o by a switch or pull chain.
The fuse (or circuit breaker) size should be 15 Amps.
For your personal safety, this appliance must be grounded. It is equipped with a power supply cord that
has a 3-pronged grounding plug. To minimize possible shock hazard, the cord must be plugged into a
mating 3-pronged wall socket and grounded in accordance with the National Electrical Code and local
codes and ordinances. If a mating wall socket is not available, it is the personal responsibility of the
customer to have a properly grounded, 3-prong wall receptacle installed by a qualied electrician.
Leveling the Refrigerator
It is important for the refrigerator to be level in order to work properly. It
can be raised or lowered by rotating the plastic sheaths around each of
the feet on the bottom of the machine. If you nd that the surface is not
level, rotate the feet until the refrigerator becomes level. You may need to
make several adjustments to level it. We recommend using a carpenter’s
level to check the machine.
1. Place a carpenter’s level on top of the product to see if the refrigerator
is level from front to back and side to side.
2. Adjust the height of the feet as follows:
Turn the leveling feet to the right to lower that side of the refrigerator.
Turn the leveling feet to the left to raise that side of the refrigerator.
Note: Once you are ready to install the unit in a cabinet or directly on the oor, you must
adjust the feet to level the refrigerator.
To Next Page
Loading...
Need help?
General
