Edgetech 4125 - 2 Specifications

2-1
2.0 SPECIFICATIONS
The electrical interface between the 4125 LT and the SeaSPY II or the Mini Explorer is via an 8-pin Micro
Subconn connection (MCIL8F/MCBH8M) through a Y-Splice cable (see F
IGURE 1-5) provided by EdgeTech.
The RS-232 interface is setup for 9600 baud, 8 bits, 1 stop, no parity.
SPECIFICATIONS
PIN OUT SPECS
Pin 1
12 VDC
Pin 2
GND
Pin 3
Side Scan Tx / Mag Rx (RS-232)
Pin 4
Side Scan Rx / Mag Tx (RS-232)
Pin 5
Return and RS-232 Ground
Pin 6
N/C
Pin 7
N/C
Pin 8
N/C
OPERATING SPECS
Mini Explorer
8V Min / <0.5 A
(or internal fuse in Mini Explorer will trip)
SeaSPY2
(See Note Below)
9V Min / <0.5 A
(or internal fuse in SeaSPY2 will trip)
POWER SPECS
Max Power
0.5 Amp @ 12.5 VDC
Table 2-1: Magnetometer Interface Specifications
NOTE: SeaSPY2 Cable Interface from Marine Magnetics Part Number,
TCSSS-T-4125, is required when interfacing a SeaSPY2 with a 4125 LT Side
Scan Tow Fish.