To Next PageTo Next Page
Need help?Do you have a question about the Edgetech 2205 and is the answer not in the manual?
Describes the primary J1 connector for power, triggers, and network connectivity.
Explains the J2 connector, used for optional sound velocity devices.
Describes J3 and J11 connectors, typically for bathymetric systems.
Details the connectors for the sub-bottom transmit transducer array.
Explains the J5 and J9 connectors for the side scan transducer arrays.
Describes the connection for the sub-bottom PVDF receiver.
Explains system trigger signal generation and handling for synchronization.
Notes that the system has no onboard data storage; data is streamed.
Details the integrated pressure sensor and its real-time output.
Explains SONAR.INI settings for timing synchronization via NMEA and 1pps.
Provides example SONAR.INI settings for various system configurations and frequencies.
Details SonarSerial.INI settings for motion sensors and network data.
Explains the authorization password system tied to Machine ID for system access and features.
Provides instructions for accessing system disk drives and files using Remote Desktop.
Outlines steps for resetting the EdgeTech folder for troubleshooting or reinstallation.
Details the procedure for establishing an FTP server on the SONAR CPU.
Lists capacitance measurements for side scan transducers at various frequencies.
Details capacitance measurements for the sub-bottom hydrophone receiver.
Provides impedance and admittance values for side scan transducers at different frequencies.
Describes the housing of system electronics in a 2000-meter rated pressure housing.
Provides crucial safety instructions for opening the pressure housing.
Explains sea ground connection requirements for proper operation and noise reduction.
Discusses the installation angle and spacing of side scan arrays.
Details the mounting of the sub-bottom transmit transducer and PVDF receiver.
Provides instructions for cleaning and inspecting the system after water retrieval.
Advises visual inspection of the connector endcap and sacrificial zinc.
Details procedures for inspecting and cleaning underwater connector pins and sockets.
Describes the primary J1 connector for power, triggers, and network connectivity.
Explains the J2 connector, used for optional sound velocity devices.
Describes J3 and J11 connectors, typically for bathymetric systems.
Details the connectors for the sub-bottom transmit transducer array.
Explains the J5 and J9 connectors for the side scan transducer arrays.
Describes the connection for the sub-bottom PVDF receiver.
Explains system trigger signal generation and handling for synchronization.
Notes that the system has no onboard data storage; data is streamed.
Details the integrated pressure sensor and its real-time output.
Explains SONAR.INI settings for timing synchronization via NMEA and 1pps.
Provides example SONAR.INI settings for various system configurations and frequencies.
Details SonarSerial.INI settings for motion sensors and network data.
Explains the authorization password system tied to Machine ID for system access and features.
Provides instructions for accessing system disk drives and files using Remote Desktop.
Outlines steps for resetting the EdgeTech folder for troubleshooting or reinstallation.
Details the procedure for establishing an FTP server on the SONAR CPU.
Lists capacitance measurements for side scan transducers at various frequencies.
Details capacitance measurements for the sub-bottom hydrophone receiver.
Provides impedance and admittance values for side scan transducers at different frequencies.
Describes the housing of system electronics in a 2000-meter rated pressure housing.
Provides crucial safety instructions for opening the pressure housing.
Explains sea ground connection requirements for proper operation and noise reduction.
Discusses the installation angle and spacing of side scan arrays.
Details the mounting of the sub-bottom transmit transducer and PVDF receiver.
Provides instructions for cleaning and inspecting the system after water retrieval.
Advises visual inspection of the connector endcap and sacrificial zinc.
Details procedures for inspecting and cleaning underwater connector pins and sockets.
General
