2205 System Technical and User’s Guide
Document : 0022175 Rev A Page 4
1. ERRATA
CAUTION
Operation of Arrays IN-AIR will cause sensor failure due to inadequate heat
dissipation. Arrays should be operated IN-AIR for a period of no more than 5
minutes. Setting Transmit Power to 0% will allow arrays to Receive signals
without Overheating when conducting noise analysis or Rub Tests.
CAUTION
The 2205 utilizes a Push – Pull amplifier design for Side Scan transmission. You
can NOT adjust the transmit level in the same manner as a linear amp (utilized
on the 2200 series). DO NOT attempt to adjust the transmit power with
JStar/Discover/Third Party Software to anything other than 100% (ON) or 0%
(OFF). Doing so could harm the electronics.
To Next Page
Loading...
