2205 System Technical and User’s Guide
Document : 0022175 Rev A Page 7
5. Connector/Internal Cable Configuration
A typical electronics block diagram is provided in drawing 0021984 where it identifies the internal
cabling and how it relates to the external connectors. The end cap configuration is depicted in Figure 5-1
and in drawing 0021985. Unused connectors are sealed with removeable plugs.
Figure 5-1. End Cap
5.1 J1 Connector – Power, 2x Trigger, 10/100 Ethernet
J1 provides connection for two 36-60Vdc inputs, 2x triggers, and 10/100 Ethernet. The embedded CPU is
shipped with an IP address of 192.9.0.101 and SubNet Mask of 255.255.255.0. This connector’s
configuration is provided in Table 5-1. To operate the system as a Side Scan and Sub-Bottom SONAR
processor, 48vdc (nominal) must be applied to both pairs of input power connections. If only Side Scan
will be used, power to pins 1 & 3 is required. Refer to drawing 0022208 for wiring configuration.
To Next Page
Loading...
Need help?
General
