3-7
3.2 Configure the Topside
The Topside DISCOVER software needs to be setup to allow the serial data to be set to the selected COM
port. To setup the topside running DISCOVER, shown in F
IGURE 3-16, and the instructions below:
1. Open DISCOVER on the PC or Laptop.
2. On the pull-down bar, select the Configuration-> Serial Ports.
Figure 3-11: Discover Configuration Drop-Down Menu
3. In the “Serial Configuration” menu, use the “Enable Remote COM Port” highlighted below:
Figure 3-12: Serial Configuration
To Next Page
Loading...
