3-8 3.0 SETUP
4125 MAGNETOMETER INTERFACE 0016510_REV_C
4. Click ‘Port’ drop-down menu to view available COM Ports; select an available COM Port.
Figure 3-13: Enable Remote COM Port, Port
5. Select the ‘Baud Rate’ button and select “9600” for the serial device; if not already selected
Figure 3-14: Enable Remote COM Port, Baud Rate
6. Select the ‘Logical Port’ Button and select “COM5”; which is the magnetometer data sent thru the
remote sonar serial Input/Output interface
Figure 3-15: Enable Remote COM Port, Logical Port
To Next Page
Loading...
