Setup Wizard
NOTE
Do set-up at least the first time the
system is used.
The Setup Wizard is a step-by-step procedure to be followed before using the
FlightScope. It can be skipped if the set-up remains unchanged between use,
but should be repeated if the set-up changes (e.g. if the system is moved to
a different location).
The Setup Wizard can be started from the Main screen menu or from the
Advanced Settings (F10) menu.
Step-by-step procedure
Setup 1. Connection (by USB cable)
Connect the sensor to the PC and turn power on. Run the FlightScope
software and choose Setup Wizard.
On the Communications screen (right) choose
Refresh to list the available connections.
Open the list of Sensor Devices and select the indicated FlightScope in the
list (see example below). Then click “Open”.
The sensor will now connect and showing the selected COM port as “Open”.
Click “Next” to continue to sensor mode and geometry, or “Finish” to exit
Setup Wizard.
To Next Page
Loading...
General