EDIFIER Extreme Connect MP260 - USB Audio Setup for PC Users (Windows XP); 3.5 mm Stereo Line-in

USB audio Instruction for PC Users (Windows XP)
Step 1: Connect the EDIFIER Extreme to your PC with the USB cable.
Step 2: Click “Start” Ú “Setting” Ú“Control Panel”
Step 3:
Click “Sounds, Speech, and Audio Devices” Ú “Sounds, and Audio Devices”
Page 10 Operational guide
Ú Press until the top indicator is green.
Ú Connect the 3.5mm-3.5mm Audio cable to the “LINE IN” port.
Ú Play the connected device and adjust the volume to a desired level.
*************************************************************************************************************************************
Page 11 Technical information
Power output: RMS 2W×2 (THD+N=10%, f
0
=1KHz)
Signal to noise ratio: ≥85 dBA
Frequency response: 190Hz~18KHz (@+/-6db)
Input sensitivity: 500mV ± 50mV (THD+N=1%)
Adjustment: Buttons on the top of speaker
Input type: Bluetooth/Micro SD/USB audio/AUX (3.5mm stereo)
Micro SD card specification:
MAX capacity: 32GB
Disk Format: FAT32
3.5mm Stereo line-in
Step 4: Set the Hardware: “EDIFIER Extreme Connect”, then click “OK”.
Step 5: Open audio medium and play. Adjust the volume to a desired level.
green