EDIFIER W200BT - Bluetooth Pairing; Connect Two Bluetooth Devices Simultaneously

Press and hold for 5 seconds
to turn the headphone on,
wait until red and blue light
ashes alternately, entering
pairing state;
1. When turned o, press and hold the multifunctional button for
5 seconds to turn the headphone on, wait until red and blue light
ashes alternately, then the headphone enters pairing state;
2. Set the mobile phone to search for and connect to “EDIFIER W200BT”,
after pairing is successful, blue light will ash slowly.
● Bluetooth Pairing
1. Pair the headphone with the rst device;
2. Restart the headphone; press and hold the multifunctional button for
5 seconds to let it enter pairing state and pair with the second device;
3. Operate the rst device to pair with the headphone again, then it is
successfully connected with two devices simultaneously.
● Connect Two Bluetooth Devices Simultaneously
EDIFIER W200BT