14
ENGLISH
CHECKING THE ELECTRICAL CONNECTIONS
(the power socket must be located in an
easy to access position)
The stove is equipped with an electrical power cord
or connection to a 230V 50 Hz socket, preferably with
electromagnetic cutout.
Variations in voltage of more than 10% can compromise
the operation of the stove.
The electrical system must be compliant; check the
operation of the earth in particular.
Edilkamin is not responsible for malfunctions resulting
from an improperly earthed system.
The power line must be of adequate section for the
power of the appliance.
The power cord must not come into contact with the
hot parts of the stove, including the fl ue.
Power up the stove by setting its switch from 0 to 1.
One fuses (4 A) is inserted in the socket with switch,
located on the back of the stove.
First ignition procedure
• Make sure you have read and understood this
manual
• Remove all fl ammable materials from the appliance
(manuals, labels, etc). Make sure to remove the
labels on the glass.
There may be a slight smell of paint the fi rst few times it
is ignited, however, this will disappear quickly.
INSTALLATION
LOADING THE PELLETS INTO THE
PELLET TANK
Slide the top to load the pellets
Use BS EN ISO 17225-2 category A1 wood pellets
Use BS EN ISO 17225-2 category A1 wood pellets
or similar certifi ed products with the following
or similar certifi ed products with the following
characteristics – diameter: 6 mm; maximum length:
characteristics – diameter: 6 mm; maximum length:
4 cm, maximum moisture: 10 %, minimum calorifi c
4 cm, maximum moisture: 10 %, minimum calorifi c
value: 4100 kCal/kg. For example, ENplus certifi ed
value: 4100 kCal/kg. For example, ENplus certifi ed
wood pellets.
For reasons of safety and environmental compatibililty,
DO NOT burn plastic, painted wood, coal, bark or
other such materials in the stove.
Do not use the stove as an incinerator
*
Caution
Using fuels other than those specifi ed can
damage the appliance
1) When doing so, DO NOT rest
the bag of pallets on the top
grille, since the plastic bag may
melt and damage the appliance’s
paint.
2) Use the provided gloves when
loading the stove while it is
operating and hence hot to the
touch.
Connect the product to the electricity
supply only after having completed its
assembly and mounted the cladding.
To Next Page
Loading...
Need help?
General
