Menu Description
Quick Setup Wizard
(Chapter 1)
Select your Internet connection type and then input the configurations needed to
connect to your Internet Service Provider (ISP).
General Setup
(Chapter 2)
This section contains configurations for the Broadband router’s advance
functions such as: Address Mapping, Virtual Server, Access Control, Hacker
Attack Prevention, DMZ, Special applications and other functions to meet your
LAN requirements.
Status Information
(Chapter 3)
In this section you can see the Broadband router's system information, Internet
Connection, Device Status, System Log, Security Log and DHCP client
information.
Tools
(Chapter 4)
This section contains the broadband router’s Tools - Tools include Configuration
tools, Firmware upgrade and Reset. Configuration tools allow you to Backup
(save), Restore, or Restore to Factory Default configuration for your Broadband
router. The Firmware upgrade tool allows you to upgrade your Broadband
router's firmware. The RESET tool allows you to reset your Broadband router.
7) Click on Quick Setup Wizard (see chapter 1) to start configuring settings required by your ISP so that you
can start accessing the Internet. The other sections (General Setup, Status Information and Tools) do not
need to be configured unless you wish to implement/monitor more advance features/information.
Select the section (Quick Setup Wizard, General Setup, Status Information and Tools) you wish to configure
and proceed to the corresponding chapter. Use the selections on the web management’s top right hand page
(see below) to navigate around the web-based management User Interface.
12
To Next Page
Loading...
Need help?
General
