• Set your Default Gateway to the IP Address of The Load Balancer.
• Ensure your DNS (Name server) settings are correct.
To act as a DHCP Client (recommended)
The procedure below may vary according to your version of Linux and X -windows shell.
1. Start your X Windows client.
2. Select Control Panel - Network
3. Select the "Interface" entry for your Network card. Normally, this will be called "eth0".
4. Click the Edit button, set the "protocol" to "DHCP", and save this data.
5. To apply your changes
Use the "Deactivate" and "Activate" buttons, if available.
OR, restart your system.
Page 18
To Next Page
Loading...
