PPTP Auto Dialup
• Auto Dialup –To enable or disable auto dialup for a PPTP connection. If
you decide not to use auto dialup or auto disconnect, then you have to
connect/disconnect manually.
• Disconnect After Idle –To decide the timeout for disconnecting when
there is no traffic on the connection. Enter -1 to keep the connection
always alive. Enter 0 to enable 'dial on demand by trigger'.
• Echo Time –To determine how often an Echo request is sent to the
PPTP server. Normally, leave this setting at its default value.
• Echo Retry –To determine the maximum number times that the Echo
request is allowed to be sent to the PPTP server until a response is
received. Normally, leave this setting at its default value.
Connection
Status
This displays the current connection status for PPTP
Page 27
To Next Page
Loading...
