EW-7301APg/EW-7302APg
User Manual
7
h ACK timeout support
h Adjustable transmission power: 5 levels
h Wireless site survey: for scanning the surrounding access points for connection.
• Gateway Features in the CPE Mode
h Built-in NAT mode: to support IP sharing on the LAN side for multiple users (subscribers) to get
access to the Internet.
h Built-in DHCP server for issuing local IP addresses.
h Built-in DDNS/DNS client
h Bandwidth management: to limit the uplink and downlink throughput of the system.
h Client connection control: for WISP’s operator to remotely suspend or resume the service for
subscribers at the CPE.
h IP/port forwarding and DMZ
• Security
h Data encryption: WEP (64/128-bit), WPA/WPA2 with TKIP or AES-CCMP
h User Authentication: WEP, IEEE 802.1X, WPA-PSK, WPA-RADIUS, MAC ACL, and MAC
authentication using RADIUS
h Built-in 802.1X Authenticator
h Setting for TKIP / CCMP / AES key's refreshing period
h Support IEEE 802.11 mixed mode; open and shared key authentication.
h Hidden ESSID: broadcast SSID option can be turned off to prevent SSID broadcast to the public.
h Station Isolation setting: when enabled, all stations associated with this AP can not communicate
with each other.
h Support data encryption over WDS link.
• Administration
h Web-based management interface
h Remote configuration and management
h Remote firmware upgradeable
h Software one-button-click to reset back to factory defaults
h Utilities for system configuration backup and restoration
h Two administration accounts in CPE mode:
(1) “root” for WISP’s administrator, who can change all settings including bandwidth limit
(2) “admin” for the local administrator, who can view all settings and change only some preferences
h SNMP MIBII support (v1/v2c)
h NTP time synchronization
h Watch dog: auto recovery while detecting fault in the system
h Syslog client
h Support Event Log
h Support RADIUS accounting and accounting update
To Next Page
Loading...
Need help?
General
