correspond to the IP address you want to assign to the
PrintSir.
For example, a PrintSir with the following
configuration:
Node ID: 0000B4010101 (this implies Ethernet
address is 0000B4010101),
IP address: 203.66.191.12
The entry for this PrintSir in the /etc/bootptab file
should be:
PS010101:\
:ht=1:\
:ha=0000B4010101:\
:ip=203.66.191.12:
6.3.4 RARP
The procedure below enables the RARP daemon
running on your system to respond to a RARP request
from the PrintSir and to assign the IP address to the
PrintSir.
1. Log in the host of RARP server as the superuser
(root).
2. Assign a name corresponding to the PrintSir’s IP
address. You can add this address to the
/etc/hosts file, by adding a line such as:
203.66.191.12 pserver
74
To Next Page
Loading...
