:lp=:\
:rm=203.66.191.186:\
:rp=lpt1:\
:lf=/var/spool/lpd/pserverd.log:\
:sd=/var/spool/lpd/pserverd:\
:mx#0:
Lines should be indented with tabs. More than one printer
name can be used, with variants separated by vertical bars
(name1|name2).
The rm= entry should correspond to the IP address you have
assigned to the PrintSir. You can also use a host name if
you have assigned one in the /etc/hosts file.
The sd= entry should correspond to the spool directory you
created in the previous step.
The rp= entry should correspond to the port name of the
remote printer. The values should be one of lpt1, lpt2 or
lpt3 depends on the printer port.
The PrintSir should now be available for printing from your
Unix host.
6.6 Print a Test Page
To print to the PrintSir, you can use the lpr command:
lpr -Pprinter-name file ...
or, you can use the lp command on SCO Open Server:
77
To Next Page
Loading...
