© Edwards Limited 2012. All rights reserved. Page 35
Edwards and the Edwards logo are trademarks of Edwards Limited.
Service, spares and accessories
A373-10-880 Issue R
7.5 Accessories
7.5.1 Introduction
A range of accessories is available for the E2M28 and E2M30 pumps, as shown in Figure 10.
The accessories are briefly described in the following sections. Refer to Table 13 for the Item Numbers of these
accessories.
7.5.2 Inlet catchpot
The Inlet Catchpot traps any liquid droplets and prevents their entry into the pump.
7.5.3 Inlet dust filter
The Inlet Dust Filter protects the pump against abrasive dust.
7.5.4 Inlet desiccant trap
Use a Desiccant Trap when you pump limited quantities of water vapour at high pumping speeds to a low vapour
pressure.
7.5.5 Inlet chemical trap
The Inlet Chemical Trap protects the pump against chemically active gases.
7.5.6 Outlet mist filter
The Outlet Mist Filter separates and traps oil droplets in the pump outlet to prevent oil mist discharge. The Mist Filter
is supplied with an adaptor to connect it to the pump outlet.
Table 13 - Accessory item numbers
Accessory Item Number
ITO20K Inlet Catchpot A441-10-000
ITF20K Inlet Dust Filter A442-15-000
ITD20K Inlet Desiccant Trap A445-10-000
ITC20K Inlet Chemical Trap A444-10-000
EMF30 Outlet Mist Filter A462-33-000
PV25EK Valve: 200/240 V, 1-phase, 50/60 Hz C413-01-000
PV25EK Valve: 110/127 V, 1-phase, 50/60 Hz C413-03-000
FL20K Foreline Trap A133-05-000
Vibration Isolators (pack of four) A248-01-412
ODE 1/4 Oil Drain Extension A505-03-000
Pump Inlet Adaptor C105-20-201
Flexible Bellows C105-11-670
Pump Outlet Adaptor C105-01-414
Gas Ballast Banjo Elbow Assembly A500-06-003
Gas Ballast Valve: 110 V, 50/60 Hz A500-06-984
Gas Ballast Valve: 240 V, 50/60 Hz A500-06-930
To Next Page
Loading...
