EasyManua.ls Logo

Edwards iXH3030TX User Manual

Edwards iXH3030TX
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
M561-00-880
Issue C Original
Instruction Manual
iXH, iXL and pXH Dry Pumping Systems

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Edwards iXH3030TX and is the answer not in the manual?

Edwards iXH3030TX Specifications

General IconGeneral
ModeliXH3030TX
Cooling MethodAir Cooled
Frequency50/60 Hz
TypeDry pump
Operating Temperature12 - 40 °C
Storage Temperature-20 - 60 °C

Summary

Introduction

1.2 Applications

Details the intended applications for the pumping systems.

Technical data

2.1 General technical data

Presents detailed technical specifications and dimensions for various pump models.

2.2 Performance data

Details the typical peak pumping speed and ultimate pressure performance.

2.3 Loading data

Provides loading data including center of gravity and load at leveling feet.

2.5 Electrical data

Lists electrical specifications including motor ratings, current, and cable sizes.

2.6 Cooling-water data

Details specifications for the cooling water system, including pressure and temperature.

Installation

3.1 Locate the dry pumping system

Provides instructions for safely positioning and leveling the pumping system.

3.3 Connect the dry pumping system to your vacuum/exhaust system

Instructions for connecting the pump to vacuum and exhaust systems.

3.5 Connect the nitrogen supply

Details the connection of the nitrogen supply and its requirements.

3.5.1 Flammable/pyrophoric materials

Safety precautions when pumping flammable or pyrophoric materials.

3.7 Electrical supply

Guidelines for connecting the pumping system to the electrical supply.

3.7.1 Mains supply cable connection

Detailed instructions for connecting the main supply cable to the pump connector.

3.10 Connect and set up the cooling-water

Steps to connect and set up the cooling water supply and regulate flow.

3.12 Commission the system

Step-by-step guide for commissioning the pumping system.

Operation

4.1 Start-up

Procedures for safely starting up the pumping system.

4.3 Manual shut-down

Procedures for manually shutting down the pumping system.

4.4 Automatic shut-down

Explains automatic shut-down behavior based on alarm conditions.

4.5 Unplanned shut-down and alarms

Details pump protection sensors that trigger warnings and alarms.

4.6 Emergency stop

How to use the emergency stop switch to shut down the system.

4.7 Restart the pump after an emergency stop or automatic shut-down

Procedures for restarting the pump after a shutdown event.

Maintenance

5.1 Safety and maintenance frequency

General safety precautions and frequency guidelines for maintenance.

Service, spares and accessories

7.2 Service

Details Edwards' global service network and available support options.

Appendix A2 Troubleshooting

A2.1 Warnings

Information on how the pump controller generates and displays warnings.

A2.2 Alarms

How the pump controller generates and indicates alarms, and system shutdown behavior.

A2.3 Inverter warnings and alarms

How to decode inverter warning and alarm codes displayed by the PDT.

Related product manuals