eeese Emil - Technical Specifications; Performance and Capacity Details

MV-2502-2508-08-2022
.
eeese-aircare.com © All rights reserved eeese air care a/s
83
UK
Dehumidier is
blowing out warm
air
The dried air is passed over
heating coils before it is blown
into the room as part of the
dehumidifying process
This is normal, a dehumidier is
not an air cooler
The display is not
showing the hu-
midity set point
The display shows the room rel-
ative humidity not the set point
Press the humidity control
button once to see the target
relative humidity
Water on oor
There is residual water in tank,
and the device is lurched too
much by moving
Be careful when moving the
tank
The dehumidier is
noisy
The air lter is blocked or the
device is on an uneven surface
Clean the lter or put the de-
vice on a at surface
10. Technical Specications
Model Emil Art. no 2508 2502
Max. working area m
2
40 50
Timer, h 1 ~ 24
IP code IPX2
Power Supply 220-240V - 50Hz
Dehumidifying Capacity, L/day (30°C RH 80%)
10 12
6.5 7.5
Dehumidifying Capacity, L/day (27°C RH 60%)
Power Consumption, W 165
Air Volume m
3
/h
High 105
Low 80
Noise Level dB(A)
High 40
Low 36
Water Tank Capacity, L 2.6
Operating Temperature, °C 5~35
Refrigerant R290
Compressor Piston
Net Weight, kg 11.3 11.6
Filter Washable
WiFi No Yes
Drain Hose Diameter mm 14
Length of cable, cm 190
Product Size (WDH), mm 300 × 250 × 463
The above technical data are for reference only. We reserve the right to modify them
without notice.